Step 1: Assemble Your Materials
There aren’t many items needed for this easy process. Obviously, the most important item to own is your bong.
Next, grab an estimating tape or ruler. On the off chance that you don’t have both of those, get a pencil and a penny. (Attempt your sofa pads for these.) Bong down stem sizes are genuinely direct: the most widely recognized are 10mm, 14mm, and 18mm. Your pencil and coin are a critical piece of how to gauge a down stem.
Step 2: Examine Your Joint
two pennies on a solid base
A penny’s exact measurement is 19 mm. To determine the size of your joint, you will use your coin.
Start with your bong’s female ground joint. It’s 10mm if you can hardly fit a side of the coin into the opening (or in the unlikely event that you couldn’t even slide a pencil into it). It’s a 14mm joint, just in case the penny fits in a quarter of the way. If it fits about in the middle, the joint is 18 mm.
Need to gauge bong down stem sizes for a male joint? Comparative estimating applies. In the event that your joint covers a little part of the penny, it’s 10mm. In the event that it covers about ¾ of the penny, it’s 14mm. Assuming that it covers practically the penny, it’s all’s 18mm.
Step 3: Measure Your Downstem Length
The length is taken into account while calculating the down stem. Here’s where you use your pencil.
Insert the pencil into your bong’s female ground joint so that the tip floats about ½” above the base. If the line was full, it would ideally create quite the commotion throughout the town. Where the pencil comes out of the joint, leave an impression.
Currently, measure from the pencil tip to that impression to determine the size of your bong down stem. Remember that the length of the glass ground joint is sometimes not included in down stem measurements. To acquire the perfect length, subtract one inch from the estimate you made from your pencil because these joints are typically one inch long.
Try avoiding using a ruler? Remember, pennies have a width of 19 mm. To get an approximate estimate, count the number of pennies that fit from the pencil tip to your imprint, then multiply the result by 19 (be sure to subtract 1 inch or 25 mm).
In the event that you have a 10mm joint and can’t fit a pencil inside, different choices incorporate the ink supply of a pen or you can perhaps tape a few toothpicks together when absolutely necessary.
That is all there is to it, presently you know how to quantify a down stem!
